NCR 7600 - Installing a Secondary Display (Dual Display)

Hardware Installation 23
Installing a Secondary Display (Dual Display)
The7600MotherboardusesanintegratedvideocontrollerwiththeIntel945GSE
GMCHchipset.ThiscontrollerprovidesaMonitorport(VGA)andaDigitalDisplay
port(DVI)onthemotherboardconnectorrow.Thesetwoportsprovideasingle
displaymode(DVIorVGA)oradualdisplaymode(DVIandVGA).
Dualdisplay
modecanbeaclone(samevideodatadisplayedonbothdisplays)oranextended
desktop(thedesktopspansacrossbothdisplays).
ThedualmodeisconfiguredusingtheIntel
®GraphicsMediaAcceleratorcontrolpanel.
1. Powerdownthesystem.
2. Connectthesecondarydisplay.
Note: Bothdisplaysmustbeconnectedtothe7600beforepoweringupthesystem.
3. Applypowertothesystem.
4. RightclicktheDesktopandthenselectGraphics Propertiesfromthemenuto
startthecontrolpanel.Thefollowingscreenindicatesthe
systemwaspreviously
configuredwithasingleVGAdisplay.