NCR 7600 - Chapter 5: BIOS Updating Procedure; Introduction; Prerequisites

Chapter 5: BIOS Updating Procedure
Introduction
ThischapterdiscussesproceduresonhowtoupdatetheterminalBIOS.Thesoftware
isdistributedviatheNCRWebsite.
TheBIOSupdatecanbeperformedusingthefollowingmethods:
• BootableUSBCDDrive
• BootableUSBMemoryDevice
•Network‐RefertotheNCRRetailSystemsManager(RSM)SoftwareUserʹsGuide,
(B005‐0000‐
1518)forinformationaboutthisprocedure.
Prerequisites
ThefollowingarerequiredtoperformaSPI/BIOSupdate.
•USBKeyboard
• BIOSSoftware.DownloadfromtheNCRwebsite:
http://www.ncr.com
1. Atthissite,selecttheSupporttab.
2. SelectDrivers and Patches → Retail Support Files → NCR RealPOS
and SelfServ Terminal and Operating Systems →
NCR RealPOS 40 (7600) → BIOS.
3. SelectthedesiredBIOSFile.
•ISOImage‐UsedwithCDROMbootdevice
•DiskImage‐UsedwithFloppyDiskbootdevice
•NetworkImage‐UsedwithNetworkboot
•USBMemoryKeyImage‐UsedwithUSBbootdevice
4. Save
thesoftwaretoyourlocalharddrive.