NCR 7600 - Chapter 3: BIOS Setup; Entering Setup; How to Select Menu Options; Restoring Factory Settings

Chapter 3: BIOS Setup
Entering Setup
1. ConnectanalphanumericUSBkeyboardtotheterminal.
2. Applypowertotheterminal.
3. WhenyouseetheNCRlogodisplayedpress[Del].
How to Select Menu Options
Thefollowingkeyboardcontrolsareusedtoselectthevariousmenuoptionsandto
makechangestotheirvalues.
•Usethearrowkeystoselect(highlight)optionsandmenuscreens.
•Usethe[Enter]keytoselectasubmenu.
•Usethe[+]and[-]keystochangefieldvalues.
•Toview
helpinformationonthepossibleselectionsforthehighlighteditem,press
[F1].
•Tosavethechanges,movethecursortotheExitMenu,selecteitherSave
Changes & ExitorSave Changes,andpress[Enter].
Restoring Factory Settings
Toresetallvaluestotheirdefaultsettingsforthecurrentscreen,press[F9]andthen
[Enter]whentheconfirmationmessageisdisplayed.Theterminalautomatically
loadstheBIOSdefaultvalues.ToresetallBIOSsettingstotheirdefaultsettingsgoto
theExitmenu,pressF9,select
eitherSave Changes & ExitorSave Changes,and
press[Enter].
Note: The7600Motherboardisusedonotherproductsandhasajumperthatisused
toselecttheproperBIOSdefaults.IftheMotherboardisreplacedbesurethisjumper
issettotheRSDsetting.
SeetheBIOSDefaultSettingssectionslater
inthischapterforthepre‐installedSetup
defaults.