Getting Started
How To Use The VGA Enhanced Rear Operator Panel
NCR
SHUVRQD
V
ATM Operator Manual 2-33
The five indicators on the VEROP have the following
meanings:
●
IN-SERVICE - this is illuminated to show that the
ATM is ready for transactions
●
SUPERVISOR - this is illuminated to show that the
ATM is in the Supervisor Mode and not open for
transactions
●
ERROR - this is illuminated to show that a system
error has occurred
●
POWER - this is illuminated to show that the VEROP
is receiving power from the ATM
●
COMM - this flashes to indicate that the ATM is
communicating with a host system.
When the door is closed, and the ATM is in normal
mode, the VEROP will display any SOH messages, or a
TERMINAL HEALTHY
message.
When the terminal enters the Supervisor Mode, the
operator panel will also display the SOH messages.
The Supervisor switch is used to enter the Supervisor
Mode.
The Reset switch will cause a reset of the entire terminal.
The contrast control is used to adjust the brightness of
the display panel.
Book.bk Page 33 Thursday, March 11, 1999 2:24 PM
To Next Page
Loading...