NCR RealPOS 25 - Page 98

4-88 Entering Setup
. Interlock Switch [Disabled]
. Port Multiplier [Disabled]
► SATA Port 1 Configuration
. Port Location [Internal]
. Hot Plug [Enabled]
. Interlock Switch [Disabled]
. Port Multiplier [Disabled]
North Bridge Configuration
Clock Spread Spectrum [Min Spread Spectrum]
Primary Display Selection [IGD]
DMI ASPM [Enabled]
► IGD Configuration
. IGD - Boot Type [VBIOS Default]
. IGD - Panel Scaling [Auto]
South Bridge Configuration
SMBUS Device [Enabled]
Enable Serial IRQ [Enabled]
Serial IRQ Mode [Continuous]
CLKRUN# Logic [Enabled]
ICH Internal LAN [Enabled]
Wake on LAN [Enabled]
LAN OPROM Selection [Enabled]
HPET Support [Enabled]
HPET Memory Map BAR [F#D00000]
State After G3 [Last State]
► SB Azalia Configuration
. Azalia [Enabled]
. Azalia PME Enabled [Enabled]
. Azalia Vci Enabled [Enabled]
► SB USB Configuration