Chapter 6: BIOS Updating Procedure
Introduction
This chapter discusses procedures on how to update the terminal BIOS. The software is
distributed via the NCR Website.
The BIOS update can be performed using the following methods:
• Bootable USB CD Drive
• Bootable USB Memory Device
• Network - Refer to the NCR Retail Systems Manager (RSM) Software User's Guide,
(B005-0000-1518) for information about this procedure.
Prerequisites
The following are required to perform a SPI/BIOS update.
• USB Keyboard
• BIOS Software. Download from the NCR website:
http://www.ncr.com
1. At this site, select the Support tab.
2. Select Drivers and Patches >> Retail Support Files >>
NCR RealPOS and SelfServ Terminal and Operating Systems >>
NCR RealPOS XR6 Rel. 1.0 (7603-1xxx) >> BIOS.
3. Select the desired BIOS File.
• ISO Image - Used with CD ROM boot device
• Disk Image - Used with Floppy Disk boot device
• Network Image - Used with Network boot
• USB Memory Key Image - Used with USB boot device
4. Save the software to your local hard drive.
To Next Page
Loading...
