Hardware Installation 2-59
1. Locate the Display Mount within 4 meters (13 ft.) of the host terminal.
2. Determine if the cable should be routed down through the mounting surface or if it
should be run on top of the surface. Drill a hole if necessary.
3. If you are installing with a post greater than 215 mm (8.5 in.) secure the Base Plate
with screws (4) that are appropriate for the surface that you are installing the Base
Plate to.
4. Connect the Interface Cable to the Display Module, either RS-232 or USB.
31174
RS-232 Connector
USB Connector
To Next Page
Loading...
