ZeroWire® Embedded Technology | 31
Wireless Linking Status Messages
When initiating a link, the typical sequence of status messages presented on the Receiver display begins with
“Searching for Transmitter” and a reminder to activate the Transmitter.
When restoring power to a previously linked system, the typical sequence of status messages presented on the
Receiver display begins with “Searching for Transmitter.
”
Stage 1: Searching for Transmitter - If not activated already, activate on ZeroWire Transmitter
Stage 2: Establishing Link
Stage 3: Wireless Linked
Stage 1: Searching for Transmitter
Stage 2: Establishing Link
Searching for Transmitter If not activated already, activate on ZeroWire Transmitter
Searching for Transmitter
To Next Page
Loading...
Need help?
General
