NEC DS1000 Manual

Features
2 DS1000/2000 Feature Handbook Supplement
●
Receive an Intercom voice announcement or answer an Intercom call by lifting the hand-
set or pressing SPK .
●
Press SPK to cancel Auto Redial.
●
Lift and replace the handset.
●
Press the CANCEL soft key (Super Display only).
Note: If a Caller ID call rings while Auto Redial is enabled, your display will show the number
and optional name of the incoming caller. However, the ringing does not cancel Auto Redial.
In addition, the Auto Redial display will be restored after the Caller ID call stops ringing.
Call Forwarding
Call Forwarding Key
You can have a key on your telephone or DSS Console assigned as a Call Forwarding key.
●
While the extension is idle , pressing the key puts your extension in the Call Forwarding pro-
graming mode - the same as pressing ICM and dialing *3.
If you have Call Forwarding enabled, and you press the key and wait (for at least 6
seconds), Call Forwarding automatically cancels.
If you have Call Forwarding disabled, and you press the key and wait (for at least 6
seconds), the prior Call Forwarding mode is automatically enabled (if any).
●
While your extension is busy , pressing the key switches Call Forwarding on and off.
To set up your Call Forwarding Key, use the #KP User Programmable Features (code 27). Ask your
Communications Manager if you have access to the Use Programmable Features.
Confirmation Tone Added
You will hear a single confirmation beep after enabling or cancelling Call Forwarding.
Soft Key And Type Enhancements
If you have a display telephone, you can set up Call Forwarding by using your dial pad or your new
soft keys. In addition, you can set up Call Forwarding to reroute all calls or just trunk calls.
If you have a 22-Button or 34-Button Display Telephone
To activate Call Forwarding:
1. Press ICM and dial *3 , or press your Call Forwarding key.
OR
Press PGM + CFWD .
Call Forwarding Key BLF
This flash rate:
Means:
Off Call Forwarding is disabled.
Fast flash The extension is in the Call For-
warding programming mode.
Wink off Call Forwarding is enabled at the
extension

NEC DS1000 Specifications

General

Brand	NEC
Model	DS1000
Category	Telephone
Language	English