Features
DS1000/2000 Feature Handbook Supplement 11
- Dial 2 or press ALL to forward all calls.
- Dial 8 or press TRUNK ONLY to forward just trunk calls.
6. Once returning to idle, your telephone display will show:
- FWD OFP indicates that Off Premise Call Forwarding is enabled, followed by the number.
- If you selected a Speed Dial bin with a stored name, the name will display instead.
To cancel Call Forwarding Off Premise:
1. Press the ICM key and dial *3, or press your Call Forwarding key
OR
Press PROGRAM + CALL FWRD. You see:
2. Press NONE.
OR
Dial 0.
OR
Press CLEAR.
3. Off Premise Call Forwarding is cancelled.
If you have a 22-Button Non-Display Telephone
It is strongly recommended that you use a display telephone when setting up Off Premise Call For-
warding. If you don’t have a display telephone, the following procedure explains how you can use a
22-button non-display set to enable Off Premise Call Forwarding.
To set up Call Forwarding Off Premise:
1. Program the number you want Call Forwarding Off Premise to dial into one of your Personal
Speed Dial bins (701-720).
You must do this before proceeding to step 2 below.
For example, the following sequence programs the number 12039265400 with the
name NEC to go out over trunk group 0:
#77 + 701 + HOLD + 90 + HOLD + 12039265400 + HOLD + 62 + 32 + 23 +
HOLD + SPK.
2. Press the ICM key and dial *33.
3. Dial 2 and enter the Personal Speed bin number you programmed in step 1 above + HOLD.
To Next Page
Loading...
Need help?
General
