NEC DS2000 Hardware Manual

Connecting Blocks
DS2000 Hardware Manual Section 2: PCB Installation ◆ 2-13
2
Figure 2-15: 8-Pin (RJ61X) Jack Pinouts
RJ61X
Pin
Latch
faces up
To CPU
Mod Jack
Note
reversal
Port
Designation
To 66 Block
WHT-BLU (1T)
BLU-WHT (1R)
WHT-ORN (2T)
ORN-WHT (2R)
WHT-GRN (3T)
GRN-WHT (3R)
WHT-BRN (4T)
BRN-WHT (4R)
80000 - 18C
4T
3T
2T
1R
1T
2R
3R
4R
1
2
3
4
5
6
7
8
The following products should help if you make your own cables. The connector is gener-
ally referred to as a RJ45 connector wired in an RJ61X configuration.
• Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or SE-166-6 modular
crimping tool).
• Hubbell BRFT4P Snap-On 8 Position Modular Plug (does not require a special crimp-
ing tool).
Check with your local supplier for other comparable products.

NEC DS2000 Specifications

General

Brand	NEC
Model	DS2000
Category	Telephone
Language	English