NEC Dterm IP - Logged Out IP Station Call Destination; Set Logged Out IP Station Call Destination

– 63 –
To cancel
Press Speaker. Receive dial tone. If cancelling for another station, press
MULTILINE APPEARANCE.
Press FWD-NA or dial “Call Forwarding – Don’t Answer” cancel code.
Receive service set tone. LED goes out at your station (or the D
term
of the
multiline station).
Press Speaker. Call Forwarding – Don’t Answer is cancelled.
Logged Out IP Station – Call Destination
To set
Lift handset or press Speaker key.
Press the FDL Key or dial “Logged Out IP Station – Call Destination” access code.
Dial destination station number; receive service set tone.
Replace handset or press Speaker key.
Logged Out IP Station – Call Destination is set.
Using the Soft Key
Press FDL Soft Key; receive special Dial Tone.
Dial destination station number.
Receive service set tone; “FORWARD SET” is displayed.
To verify (with D
term
4D/8D/16D/16LD/32D)
Press “Logged Out IP Station – Call Destination” feature key lit red or press
FDL.
Display indicates the station number calls are forwarded.
Note: With Soft Key Operation, FDL flashes on the display.
4:26 PM TUE 13 APR 2004
FORWARD CANCEL
4:26 PM TUE 13 APR 2004
FORWARD SET XXXX
4:26 PM TUE 13 APR 2004
FORWARD SET XXXX
MIC >>>
4:26 PM TUE 13 APR 2004
FORWARD XXXX