NEC Dterm IP - Call Forwarding - Dont Answer; Set Call Forwarding - Dont Answer

– 62 –
Call Forwarding – Don’t Answer
To set
Press Speaker. Receive dial tone.
If setting for another station, press
MULTILINE APPEARANCE.
Press FWD-NA or dial “Call Forwarding – Don’t Answer” access code. Receive special dial tone.
Dial destination station or external telephone number. Receive service set tone.
FWD-NA LED lights (at your station or at the D
term
of the multiline station you are setting).
Press Speaker. Call Forwarding – Don’t Answer is set.
Using the Soft Key
Press FDN Soft Key. Receive special dial tone.
Dial destination; wait for service set tone.
“FORWARD SET” is displayed; Call Forwarding – Don’t Answer is set.
To verify (with D
term
4D/8D/16D/16LD/32D)
If verifying for another station, press MULTILINE APPEARANCE while idle.
Press FWD-NA.
Display indicates the station number calls are forwarded to.
Note 1: If recipient station is a D
term
4D/8D/16D/16LD/32D, LCD displays:
Note 2: Call Forwarding for Busy Line and Don’t Answer may be combined depending upon system programming.
Note 3: With Soft Key operation, FDB flashes on the display.
Forwarding
station
4:26 PM TUE 13 APR 2004
FORWARD SET 2000
4:26 PM TUE 13 APR 2004
FORWARD SET
MIC >>>
Forwarding
station
4:26 PM TUE 13 APR 2004
FORWARD 2000