NEC ELECTRA ELITE IPK II - CALL PARK - STEP CALL; To Park a call in the first available system orbit; To pick up a parked call

13
CALL PARK – STEP CALL
(Version 2000 or higher software is required)
To Park a call in the first available system orbit:
Note: You can Park Intercom or trunk calls.
1. Press the Hold or Transfer key.
2. Dial #6.
Note: If you hear busy tone, the orbit is busy. Proceed to step 3.
3. Dial
*
.
Note: Program 20-11-27 must be enabled in the Multiline Terminal’s
Class of Service.
4. Press Speaker to hang up.
Note: If not picked up, the call will recall to you.
- OR -
1.
Press the Hold or Transfer Key.
2. Press the DSS/BLF key programmed as #6
*
.
(The park location will be displayed in the LCD.)
3. Press Speaker to hang up.