29
SET RELOCATION
To exchange two terminals:
1. Pick up the handset or press the Speaker key.
2. Dial the Extension Data Swap Service Code - not assigned at
default.
3. Dial the Extension Data Swap Password - not assigned at
default.
4. Dial the extension to be swapped with or relocated to.
5. When successfully completed, confirmation tone will be heard
and the display will show completed.
6. Press the Speaker key twice.
CODE RESTRICTION, DIAL BLOCK
To set Dial Block:
1. Press the Speaker key.
2. Dial 600 (default).
3. Dial the 4-digit Dial Block Code (user defined).
4. Dial 1.
Note: Confirmation tone is heard.
5. Press the Speaker key to hang up.
To Next Page
Loading...
