NEC Electra Elite IPK User Manual

2 - 2 SAT End-User Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 2a Electra Elite IPK
SECTION 3SOFTWARE INSTALLATION
3.1 Installing Electra Elite IPK/Electra Elite System Administration
Terminal (SAT) End-User Software
1. Insert the SAT End-User CD in your CD ROM drive.
2. Click the Windows Start button.
3. Select Run.
4. Enter (CD drive letter [i.e. d:\]) \EliteIPKSATEU.exe and click OK.
5. Follow the on-screen instructions of the installation program.
6. To start the SAT End-User program:
• Click the Start button.
• Select PROGRAMS, Electra Elite IPK EU SAT for End-User.
• Click Electra Elite IPK SAT EU.
• Choose the following KTS Type:
<=S7000: This is used when system software is S7000 or below.
S8000: This is used when system software is S8000 only.
IPK: This is used when the system is Electra Elite IPK R1000
or higher.
• Enter the password. The default password is PASSWORD (in upper
case letters).
Important: Consult your authorized NEC Dealer for
proper setup of the KTS for SAT programming.

NEC Electra Elite IPK Specifications

General

Brand	NEC
Model	Electra Elite IPK
Category	Telephone
Language	English