1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
191
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 355
IMPORTANT: Processor %1, DIMM %2 -
This NVDIMM-N was selected for
Sanitizing/Erasing. All data saved in the
NVDIMM has been erased.
Action is not necessary.
UEFI 356
NVDIMM Error - Sanitization Error -
Processor %1, DIMM %2
(SN:%3-%4-%5-%6) - This NVDIMM-N
was selected for Sanitizing/Erasing, but
this process was not successful.
Please take actions in the following order.
1. Restart sanitization of the NVDIMM.
2. Contact your sales representative.
UEFI 357
IMPORTANT: Processor %1, DIMM %2 -
This NVDIMM is NOT a %3 NVDIMM.
Only %4 NVDIMMs are supported.
NVDIMM will be used as a standard DIMM.
Contact your sales representative.
UEFI 360
IMPORTANT: The System Programmable
Logic Device revision in this system does
not meet minimum requirements for
operation with NVDIMMs. All NVDIMM
functionality has been disabled.
Update the system programmable logic device. If the
problem persists, contact your sales representative.
UEFI 361
IMPORTANT: The Processor RAPL
wattage value is configured to an invalid
value. User provided value was %1,
but %2 has been assigned since it is
closest to %3.
Please take actions in the following order.
1. Set an appropriate value for Processor RAPL
wattage value.
2. If the problem persists, contact your sales
representative.
UEFI 362
IMPORTANT: The DRAM RAPL wattage
value is configured to an invalid value.
User provided value was %1, but %2 has
been assigned since it is closest to %3.
Please take actions in following order.
1. Set an appropriate value for DRAM RAPL wattage
value.
2. If the problem persists, contact your sales
representative.
UEFI 363
IMPORTANT: New NVDIMM(s) detected
on Processor %1. All NVDIMMs on
Processor %2 have been disabled.
Sanitize the NVDIMM connected to the corresponding
processor. If the problem persists, contact your sales
representative.
UEFI 364
NVDIMM Error - NVDIMM Controller Error -
Processor %1, DIMM %2. The controller
firmware has been corrupted. The OS will
not use the NVDIMM.
Please take actions in following order.
1. Update the NVDIMM firmware.
2. Contact your sales representative.
UEFI 371
IMPORTANT: Processor %1, DIMM %2.
New NVDIMM detected and has been
disabled.
Sanitize the NVDIMM connected to the corresponding
processor. If the problem persists, contact your sales
representative.
To Next Page
Loading...
