NEC Express5800 Series - Page 193

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
193
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 382
NVDIMM Error - Proc %1, DIMM %2 is
NOT configured for Sub-NUMA Clustering
but system is configured for Sub-NUMA
Clustering. All NVDIMMs on Proc %3 are
disabled.
Set Sub-Numa Clustering to Disabled, or sanitize the
NVDIMM. If the problem persists, contact your sales
representative.
UEFI 383
NVDIMM Error - Proc %1, DIMM %2 is
configured for Sub-NUMA Clustering but
system is NOT configured for Sub-NUMA
Clustering. All NVDIMMs on Proc %3 are
disabled.
Set Sub-Numa Clustering to Enabled, or sanitize the
NVDIMM. .If the problem persists, contact your sales
representative.
UEFI 384
NVDIMM Error - Processor %1, DIMM %2.
NVDIMM set for Channel Interleaving
disabled but system configured for
enabled. All NVDIMMs on Processor %3
are disabled.
Set Channel Interleaving to Disabled, or sanitize the
NVDIMM. If the problem persists, contact your sales
representative.
UEFI 385
NVDIMM Error - Processor %1, DIMM %2.
NVDIMM set for Channel Interleaving
enabled but system configured for
disabled. All NVDIMMs on Processor %3
are disabled.
Set Channel Interleaving to Enabled, or sanitize the
NVDIMM. If the problem persists, contact your sales
representative.
UEFI 386
NVDIMM Error - Processor %1, DIMM %2.
NVDIMM Metadata is corrupted. All
NVDIMMs on Processor %3 are disabled.
Sanitize the NVDIMM. If the problem persists, contact
your sales representative.
UEFI 387
NVDIMM Error - Processor %1, DIMM %2.
NVDIMM Metadata is corrupted. NVDIMM
is disabled.
Sanitize the NVDIMM. If the problem persists, contact
your sales representative.
UEFI 388
Uncorrectable Memory Error - The failed
memory module could not be determined.
Contact your sales representative.
UEFI 391
NVDIMM Configuration Error - Node
Interleaving is Enabled. This is NOT
supported with NVDIMMs installed. All
NVDIMMs are disabled.
Set Node Interleaving to Disabled. If the problem
persists, contact your sales representative.
UEFI 392
NVDIMM Configuration Error - The
Advanced Memory Protection mode is not
Advanced ECC. Only Advanced ECC is
supported with NVDIMMs. All NVDIMMs
are disabled.
Set Advanced Memory Protection to Advanced ECC
Support. If the problem persists, contact your sales
representative.
UEFI 393
IMPORTANT: New NVDIMM(s) detected
and all NVDIMMs have been disabled.
Sanitize the NVDIMM. If the problem persists, contact
your sales representative.