1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
205
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 3101
Unbound Trusted Platform Module (TPM)
detected.
Action is not necessary. The TPM is integrated into the
unit after being cleared.
UEFI 3102
Unused Scalable Persistent Memory
backup device detected in Box %1
Bay %2. This device will be available for
operating system usage and will NOT be
used for Scalable Persistent Memory
backup.
Confirm and set the Scalable Persistent Memory
backup device configuration properly.
If the problem persists, contact your sales
representative.
UEFI 3103
NVDIMM Error: Unsupported NVDIMM-N
configuration detected. All NVDIMMs are
disabled.
Referring to the user’s guide, change the mounting
positions or number of DIMM.
In case a problem is not resolved, contact your sales
representative.
UEFI 3105
Unsupported PCIe Card Configuration. The
PCIe device installed in Slot %1 is not
supported in the current location.
Referring to the user’s guide, change the mounting
positions of PCIe Card.
In case a problem is not resolved, contact your sales
representative.
UEFI 120
A Critical Error Event that has kept the
system from booting. -System Halted!
Contact your sales representative.
UEFI 163 Time & Date Not Set. Set the date and time of the server.
UEFI 209
Unsupported DIMM Configuration
Detected - Installed DIMM configuration
does NOT support configured AMP Mode.
System will operate in Advanced ECC
Mode. (Major Code:%1 Minor Code:%2).
For the details of the DIMM configuration required to
use the AMP mode, refer to the User's Guide.
If the problem persists, contact your sales
representative.
UEFI 210
Unsupported DIMM Configuration
Detected - Installed DIMMs could not
support the currently configured interleave
mode. (Major Code:%1, Minor Code:%2).
For the details of the DIMM configuration required to
use the interleaved mode, refer to the User's Guide.
If the problem persists, contact your sales
representative.
UEFI 211
Unsupported DIMM Configuration
Detected - Processor %1 DIMM %2. The
DIMM does not support ECC. (Major
Code:%3, Minor Code:%4).
Remove the DIMM which was pointed out. For the
details of the DIMM configuration, refer to the User's
Guide.
If the problem persists, contact your sales
representative.
UEFI 212
Processor UPI Initialization Error. A
processor UPI initialization error was
detected. %1 (Major Code:%2, Minor
Code:%3).
Contact your sales representative.
UEFI 213
Unsupported DIMM Configuration
Detected - Processor %1 DIMM %2. The
DIMM has more ranks than is supported by
this system. (Major Code:%3, Minor
Code:%4).
Contact your sales representative.
UEFI 214
Unsupported DIMM Configuration
Detected - Processor %1 DIMM %2. The
DIMM requires a frequency not supported
by the system. (Major Code:%3, Minor
Code:%4).
Contact your sales representative.
UEFI 215
DIMM Initialization Error - Processor %1
DIMM %2. The identified processor and
memory failed to initialize properly. %3
(Major Code:%4, Minor Code:%5).
Contact your sales representative.
To Next Page
Loading...
