REMOTE CONTROL
You can perform remote control of the host system at the command prompt.
Notice
Performing remote control when the operating system is running may
cause the loss of data in the host system.
The user must have an account as operator or administrator for
remote control.
Power ON
Enter the following command at the command prompt.
start /admin1/system1
Forced Power OFF
Enter the following command at the command prompt.
stop -force /admin1/system1
or
stop -f /admin1/system1
OS Shutdown
Enter the following command at the command prompt.
stop /admin1/system1
The above OS shutdown is equivalent to pressing the POWER switch
when the power of the host system is on. Your operating system
must be set to shut down when you power off the system.
System Reset
Enter the following command at the command prompt.
reset /admin1/system1
An above system reset is failed when the power of the host system is
off.
- 35-
To Next Page
Loading...