NEC EXPRESSSCOPE Engine 3 - Special Extended Commands; State Acquisition; Power State Acquisition; Lamp State Acquisition

SPECIAL EXTENDED COMMANDS
This section describes the special extended command which can do state acquisition
(powerstate, lampstate) and interrupt generation for OS dump (nmidump). The special
extended commands use the syntaxes different from the basic command's ones.
State Acquisition
You can acquire the state of the system at the command prompt:
Commands to acquire the state are executable in all user levels.
Power State acquisition
Power state acquisition command (powerstate) is executable only when current default target
is "/admin1" or "/admin1/system1".
Enter the following command, if the current default target is not "/admin1" and
"/admin1/system1".
cd /admin1
or
cd /admin1/system1
Enter the following command at the command prompt:
powerstate
One of the following responses is returned according to the power state.
power on
System power is on.
power off
System power is off.
Lamp State acquisition
Lamp state acquisition command (lampstate) is executable only when current default target is
"/admin1", "/admin1/system1" or “/admin1/system1/led1”.
Enter the following command, if the current default target is not "/admin1", "/admin1/system1"
or “/admin1/system1/led1”.
cd /admin1
or
cd /admin1/system1
or
cd /admin1/system1/led1
- 60-