2. Configuring the Host System
This chapter describes the settings necessary to configure the BMC in the host system.
DEFAULT NETWORK SETTINGS
The BMC’s default network settings are as follows:
IP Address: 192.168.1.1
User Name: Administrator
Password: Administrator
• Connect the management LAN port to the private network on which the default IP
address “192.168.1.1”is reachable. If the default IP address is not reachable on the
network, assign a new IP address to the management LAN by using the BMC
Configuration of the Off-line Tool in the host system. Refer to “Management LAN
Settings” in the next page for the settings.
For security reasons, change the above default settings (IP address, User
Name, and Password) to the ones appropriate in your network environment.
Refer to “Chapter 5: Using Remote Management” for details.
• The remote management function is enabled by default. (In some systems, the remote
management function is disabled by default.) So, If the remote management function is
not used, disable this settings by using the BMC Configuration of the Off-line Tool.
Refer to "Management LAN Settings" in the next page for the settings.
- 8-
To Next Page
Loading...