NEC EXPRESSSCOPE Engine 3 - Interrupt Generation for os Dump

Interrupt Generation for OS Dump
Create the file input-RequestPowerStateChange11.xml and enter the following command, if
you use WinRM.
winrm invoke RequestPowerStateChange
http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_PowerManagementServ
ice?__cimnamespace=root/cimv2+Name=IPMI¥_Power¥_Service+CreationClassNa
me=CIM_PowerManagementService+SystemName=Unknown.IPMI¥_BMC¥_DeviceI
D.32+SystemCreationClassName=Host_ComputerSystem
-r:https://IP_ADDRESS/wsman -username:USERNAME -password:PASSWORD
-auth:basic -encoding:utf-8 -format:xml
-file:input-RequestPowerStateChange11.xml -skipCAcheck -skipCNcheck
-skipRevocationcheck
input-RequestPowerStateChange11.xml
<n1:RequestPowerStateChange_INPUT
xmlns:n1="http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_Power
ManagementService"
xmlns:wsa="http://schemas.xmlsoap.org/ws/2004/08/addressing"
xmlns:wsman="http://schemas.dmtf.org/wbem/wsman/1/wsman.xsd">
<n1:PowerState>11</n1:PowerState>
<n1:ManagedElement>
<wsa:ReferenceParameters>
<wsman:ResourceURI>http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/
Host_ComputerSystem</wsman:ResourceURI>
<wsman:SelectorSet>
<wsman:Selector Name='__cimnamespace'>root/cimv2</wsman:Selector>
<wsman:Selector
Name='CreationClassName'>Host_ComputerSystem</wsman:Selector>
<wsman:Selector Name='Name'>Unknown.IPMI BMC
DeviceID.32</wsman:Selector>
</wsman:SelectorSet>
</wsa:ReferenceParameters>
</n1:ManagedElement>
</n1:RequestPowerStateChange_INPUT>
The above command behavior is equivalent to pressing the DUMP
switch on the host system.
Change according to your environment.
“IP_ADDRESS” : IP address of EXPRESSSCOPE Engine 3.
“USERNAME/PASSWORD”: username/password of EXPRESSSCOPE
Engine 3.
Performing interrupt generation for OS dump when the operating
system is running may cause the loss of data in the host system.
Notice
- 68-