Access log might not be correctly displayed with timestamp condition
about the log of recorded from AC ON to DC ON on host system.
Clearing access log
To move the current default target to /admin1/sp1/log1/record1, enter the following command
at the command prompt.
cd /admin1/sp1/log1/record1
Enter the following command, if you would like to clear the access log.
delete
Setting access log
To move the current default target to /admin1/sp1/log1, enter the following command at the
command prompt.
cd /admin1/sp1/log1
Enter the following command, if you would like to confirm the access log as properties of the
access log target which is /admin1/sp1/log1.
show
Enter the following command if you would like to modify a property of the setting access log.
set <Property>=<New value>
The properties which the access log target contains are as follows:
• oemnec_operationlog_enable
This specifies whether access log for the system control and the BMC setting
modification via Web browser is enabled. The valid values for this property are "2" and
"3". "2" means that the access log is enabled. "3" means that the access log is
disabled. This is the dynamic setting.
• oemnec_sshlog_enable
This specifies whether access log for login/logout of SSH is enabled. The valid values
for this property are "2" and "3". "2" means that the access log is enabled. "3" means
that the access log is disabled. This is the dynamic setting.
• oemnec_httpslog_enable
This specifies whether access log for login/logout of HTTPS is enabled. The valid
values for this property are "2" and "3". "2" means that the access log is enabled. "3"
- 44-
To Next Page
Loading...
