NEC ITL-8LD-1 - DT730 - 8 Button DESI Less Display IP Phone - Page 80

72
• TO CHANGE PASSWORD
To change an existing password, follow the procedure
below. This password is used for the following
occasions.
• To lock/unlock the telephone.
• To delete the directory data.
• To reset the telephone settings.
STEP 1: Display the Menu screen, and select Setting.
STEP 2: Select User Setting.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
STEP 3: Select Change Password.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
STEP 4: The Change Password screen is displayed.
Enter the old password and then press or
Set soft key.
STEP 5: Enter the new password and then press
or Set soft key.
Note: For the firmware version earlier than 5.0.0.0,
Back is displayed instead of Menu.
DT730/DT710
1
1
1
2
Data Backup/Restore
[Setting]
3
Download
OKMenu
↓
User Setting
4
4
Note:
The initial password is "0000". When changing
the password for the first time, enter "0000" as
the old password.
1
2
[User Setting]
3
4
5
6
7
Peripherals
OKBack
↓
Security
Incoming Call
Talk
↓
Display
Change Password
Usability
New Pass
[Change Password]
OKCancel
SetBK
1
Old Pass
Retry Pass