NEC NEAX 2000 IPS - Configuration Guide; Figure 2-9 Mounting IP-PAD Card; Neax 2000 Ips

NEAX 2000 IPS Configuration Guide
Page 18 NDA-24347, Issue 1
Mounting IP-PAD Card Chapter 2 System Configuration
Figure 2-9 Mounting IP-PAD Card
Note: This slot must be vacant except for the VCT card.
For the IP-PAD card, the card number must be assigned by the system data
programming according to the PIM and slot, which accommodates the card.
3. After mounting the card, set the MB switch to DOWN position to put the card in
service.
IP-PAD IP-PAD L/T must not
be mounted
Note NoteNote Note
IP-PAD
Card
No. 0
IP-PAD
Card
No. 1
PIM 0/2/4/6
PFT
MP12/FP12 LT11 LT10 LT09 LT08 LT07 LT06 LT05 LT04 LT03 LT02 LT01 LT00 VM
IP-PAD IP-PAD L/T must not
be mounted
Note NoteNote Note
IP-PAD
Card
No. 2
IP-PAD
Card
No. 3
PIM 1/3/5/7
PFT
LT11 LT10 LT09 LT08 LT07 LT06 LT05 LT04 LT03 LT02 LT01 LT00 VM