NEC NEAX 2000 IPS - Floor-Standing Installation Equipment; Configuration Guide; Neax 2000 Ips; Table 8-2 Required Common Equipment for Floor-Standing Installation

NEAX 2000 IPS Configuration Guide
Page 82 NDA-24347, Issue 1
Floor-standing Installation Equipment Chapter 8 System Capacity
Floor-standing Installation Equipment
Note: The number of PWR CA and BATT CA are determined by the location of battery installed (inside or outside
of PIM). As for the BATT CA, it is also required to select the appropriate type. If battery backup is not
needed, these cables are not required.
Table 8-2 Required Common Equipment for Floor-standing Installation
NO. ITEM DESCRIPTION
QTY
1 PIM 2 PIM 3 PIM 4 PIM 5 PIM 6 PIM 7 PIM 8 PIM
1
PIM PIMMD
1 2 3 4 5 6 7 8
2
TOP/BASE TOP/BASE
1 1 1 1 2 2 2 2
3
BRACKET
MOUNTING BRACKET
(Optional)
0 0 0 1 1 1 1 2
4
BASE TRAY
BASE TRAY ASSEM
(Optional)
1 1 1 1 2 2 2 2
5
PWR CA
Note
PWR CA-A
INTERNAL
BATT
0 (1) (1) (2) (2) (3) (3) (4)
EXTERNAL
BATT
0 (1) (2) (3) (3) (4) (5) (6)
6
BATT CA
Note
BATT CA INT
(for Internal BATT)
(1) (2) (3) (4) (5) (6) (7) (8)
BATT CA EXT
(for External BATT)
(1) (1) (1) (1) (2) (2) (2) (2)
7
MP Refer to the Equipment List
1 1 1 1 1 1 1 1
8
FP/BUS PN-CP15
0 0 1 1 2 2 3 3
9
BUS CABLE 48-TW-0.7 CONN CA
0 1 2 3 4 5 6 7