NEC NEAX 2000 IPS - Mounting VCT Card; Configuration Guide; Figure 2-10 Mounting VCT Card; Neax 2000 Ips

Chapter 2 System Configuration Mounting VCT Card
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Page 19
Mounting VCT Card
1. Set the card number to each VCT (PN-16VCTA) card by SW 1 setting, and
confirm the correct switch settings.
2. Mount the first VCT (VCT 0) card in the LT slots, next to the IP-PAD card
mounted in the previous procedure.
3. Mount the second VCT (VCT 1) card in the LT slots, next to the VCT 0 card.
Figure 2-10 Mounting VCT Card
Note 1: This slot must be vacant except for the IP-PAD card.
Note 2: Do not mount any other L/T cards in the LT08-LT11 slots when you mount the
VCT card in the LT06 and LT07 slots.
IP-PAD IP-PAD L/T must not
be mounted
Note NoteNote Note
IP-PAD IP-PAD
PIM 0 - 7
PFT
MP12/FP12 LT11 LT10 LT09 LT08 LT07 LT06 LT05 LT04 LT03 LT02 LT01 LT00 VM
V
C
T
V
C
T
V
C
T
V
C
T
VCT VCT
11 11