NEC NEAX 2000 IPS - WCS IP-CS Installation and Setup

Chapter 6 Cabling Internal Cabling
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Page 57
Power Control
Cable
The power control cable provides a connection between the MP and the AC/DC
power supply for controlling battery backup function and MJ/MN alarm indication.
Note: One power control cable is contained in the PIM or Base. It is not necessary
to order a separate power control cable except for spare or replacement.
DC Power Cable The DC power cable provides a connection between the AC/DC power supply for
extending the 27 VDC input in a multiple-PIM configuration, when battery backup
option is required.
An Internal Battery is installed in every PIM.
Figure 6-2 Power Cable Connection (Internal Battery Option)
Table 6-2 Power Control Cable
NAME CODE
PART
NUMBER
REMARKS
PWR CNT CA-D 151031
Power Control Cable
•For PIM 1 - PIM 7
• BWB - PZ-PW121/122
(Included in PIM)
PWR CNT CA-E 151032
Power Control Cable
•For PIM 0
• BWB - PZ-PW121/122
(Included in Base and PIM for Dual System)
P
W
R
PIM 3
BATT
B
P
W
R
PIM 7
BATT
B
P
W
R
PIM 2
BATT
B
P
W
R
PIM 6
BATT
B
P
W
R
PIM 1
BATT
B
P
W
R
PIM 5
BATT
B
P
W
R
PIM 0
BATT
B
P
W
R
PIM 4
BATT
B
A
A
A
A
BASE
BASE