NEAX 2000 IPS Configuration Guide
Page 44 NDA-24347, Issue 1
Common Control Cards Chapter 4 Circuit Cards
Ethernet Card This card provides Ethernet interface between MP and LAN for call control of Dterm
IP telephones/CCIS over IP with another NEAX 2000 IPS/2400 IPX. It also provides
interface for MATWorX and the OAI/ACD server.
Firmware
Processor (FP)
The FP provides supervision and status analysis of Line/Trunk ports, which reside in
the PIM. The FP card is installed in Slot 12 of PIM 2, 4 and 6. The FP provides the
BUS interface for I/O BUS, PCM BUS, and Alarm BUS in a multiple-PIM
configuration.
To Next Page
Loading...
