NEC PA600X - 5 Adjusting the Picture Size and Position

5
1. Introduction
Terminal Panel
(→ page 7)
Rear
Remote Sensor (located on the
front and the rear)
(→ page 9)
AC Input
Connect the supplied power cord’s
three-pin plug here, and plug the
other end into an active wall outlet.
(→ page 13)
* ThissecurityslotsupportstheMicroSaver
®
SecuritySystem.
Built-in Security Slot ( )*
Cable cover connection
(right and left)
Screw holes and grooves for the
optional cable cover
(→ page 212)
Ventilation (inlet) / Filter Cover
The wireless LAN unit’s USB (LAN)
port is located inside here.
(→ page 151, 155)
Ventilation (outlet)
Heated air is exhausted from here.
Downloaded From projector-manual.com NEC Manuals