NEC PA600X - 4 Projecting an Image from an Angle (Geometric Correction Tool in Image Express Utility Lite)

160
7. Maintenance
2. Remove the lamp housing.
(1)Loosenthetwoscrewssecuringthelamphousinguntilthephillipsscrewdrivergoesintoafreewheelingcondi-
tion.
 •Thetwoscrewsarenotremovable.
 •Thereisaninterlockonthiscasetopreventtheriskofelectricalshock.Donotattempttocircumventthis
interlock.
(2)Removethelamphousingbyholdingit.
Interlock Guide hole
To replace the lamp:
1. Remove the lamp cover.
(1)Loosenthelampcoverscrew
 •Thelampcoverscrewisnotremovable.
(2)Pullthebottomofthelampcovertowardsyouandremoveit.
CAUTION:
Makesurethatthelamphousingiscool
enoughtobeforeremovingit.
Downloaded From projector-manual.com NEC Manuals