NEC PX803UL-WH - Lens Calibration

118
5. Using On-Screen Menu
UsingtheReferenceLensMemoryFunction[REF.LENSMEMORY]
ThisfunctionservestostoretheadjustedvaluescommontoallinputsourceswhenusingtheLENSSHIFT,ZOOM
andFOCUSbuttonsoftheprojectorortheremotecontrol.Theadjustedvaluesstoredinmemorycanbeusedasa
referencetothecurrent.
PROFILE ���������������� Select a stored [PROFILE] number�
STORE ������������������� Stores the current adjusted values in memory as a reference�
MOVE �������������������� Applies the adjusted reference values stored in [STORE] to the current signal�
RESET �������������������� Reset selected [PROFILE] number [REF� LENS MEMORY] to the factory default settings�
LOAD BY SIGNAL �� When you switch signals the lens will shift to the lens shift, zoom, and focus values for the selected [PRO-
FILE] number�
If no adjusted values have been saved to [LENS MEMORY], the lens will apply [REF� LENS MEMORY]
adjusted values� Alternatively, if no adjusted values have been saved to [REF� LENS MEMORY], the unit will
return to factory default settings�
FORCED MUTE ������ To turn off the image during lens shift, select [YES]�
NOTE:
• Adjustedvaluesin[REF.LENSMEMORY]willnotbereturnedtodefaultwhenperforming[CURRENTSIGNAL]or[ALLDATA]for
[RESET]fromthemenu.
• Tostoreadjustedvaluesforeachinputsource,usetheLensMemoryfunction.(→ page 58, 101)
• When[PICTUREMUTESHUTTER]under[SHUTTERSETTINGS]is[ON],[FORCEDMUTE]willturnoffthelightsourceandstop
projection.(→ previouspage)
[LENSCALIBRATION]
Theadjustmentrangeofthezoom,focus,andshiftofthe[LENSMEMORY]iscalibrated.
Besuretocarryout[LENSCALIBRATION]afterreplacingthelens.
[LENSPOSITION]
Movethelensposition.
HOME �������������������� Set back the lens to the home position�
TYPE ���������������������� Select this for using the lens unit NP39ML� The lens position will be adjusted to the appropriate position�