EasyManua.ls Logo

NEC PX803UL-WH - Rear

NEC PX803UL-WH
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
1. Introduction
Rear
ACINterminal
Connectthesupplied
powercord’sthree-pin
plughere,andplugthe
otherendintoanactive
walloutlet.(page14)
Theftpreventionscrew
holeforthelensunit
Mainpowerswitch
WhileACpowerisbeingsupplied,setthe
mainpowerswitchtoONposition(|),then
yourprojectorwillenterastandbystate.
PowerCordStopper
(page16)
* ThissecurityslotsupportstheMicroSaver
®
SecuritySystem.
Built-inSecuritySlot( )*
SecurityBar
Fixingatheftprevention
device.
Thesecuritybaraccepts
securitywiresorchains
upto0.18inch/4.6mmin
diameter.
Handle(locatedon4posi-
tions)
Fortransportation
NOTE:
• For moving the projector,
makesureyouhaveatleast
twopeople.Attemptingto
move the projector alone
could result in back pain
or other injuries.
Intakevent
Takesinairtocooltheunit.
(pagexi,154)
Terminals
(
page9)
Exhaustvent
Heatedaiirisexhausted
fromhere.
(pagexi,154)
Controls
(
page8)

Table of Contents

Related product manuals