NEC PX803UL-WH - Geometric Correction and Security

25
2. Projecting an Image (Basic Operation)
Adjusting with the remote control
1. HoldtheCTLbuttonandpresstheECO/L-SHIFTbutton.
 The[LENSSHIFT]screenwillbedisplayed.
2. Press the ▼▲◀ or ▶ button.
 Usethe▼▲◀▶buttonstomovetheprojectedimage.
NOTE:
LensCalibration
Ifthepoweroftheprojectoriswronglyshutdownduringthemotionoflensshift,itmayshiftthehomepositionofthelensand
maycauseofmalfunction.Inthiscase,performlenscalibration.
Lenscalibrationprocedures
1.Powerontheprojector.
2.Pressthe(SHUTTER/CALIBRATION)buttononthecontrolpanelover2secondsorkeeppressingtheCTLbuttonandpressthe
INFO/L-CALIB.buttonontheremotecontrol.
 Calibrationisperformed.
TIP:
• Thediagrambelowshowsthelensshiftadjustmentrange(projectionmode:desktopfront).Toraisetheprojectionpositionhigher
thanthis,adjustbythetiltfoot.(→ page 32)
100%V
50%V
30%V
100%H
20%H
10%H
10%H
20%H
Heightofprojectedimage
Widthofprojectedimage
 Descriptionofsymbols:Vindicatesvertical(heightoftheprojectedimage),Hindicateshorizontal(widthoftheprojectedimage).