Installation Guide
QX-S5500G Series Ethernet Switches
9. Appendix B FRUs and compatibility matrixes
9-5
CAUTION:
LSWM5SP2PM and LSWM5XGT2PM operate only in 10Gbps.
LSWM5SP2PM and LSWM5SP8PM are supporting 10GBASE-ER-SFP+ and 10GBASE-ZR-SFP+
module.
The SFP/SFP+ port in front of switch aren't supporting 10GBASE-ER-SFP+ and 10GBASE-ZR-SFP+
module.
NOTE:
You must use Category6 cable or better (including, Cat6 and Cat6A).
The Interface card status LED on an expansion interface card doesn't influence in the state of the port
mode of the switch.
For more information about these interface cards, see “Port mode LED“ of “Appendix C Ports and LEDs”.
I. LSWM5QP2P
To Next Page
Loading...
