NEC SL1100 - Figure 2-14 EXIFB-C1 PCB Installation; Figure 2-15 Removing the Plastic Knockouts; Figure 2-16 Replacing the Main-Cover

4. Press tab A and lift the CPU support bracket.
CPU support
CPU support
EXIFB-C1 PCB
084M-B1 at 1228M KSU
J1
A
Figure 2-14 EXIFB-C1 PCB Installation
5. Insert the EXIFB-C1 PCB into the J1 connector on the 084M-B1 at 1228M-B KSU.
6. Close the CPU support and make sure the tab A locks into place.
7. Cut and remove the Plastic Knockouts as needed for Expansion KSU.
Main-Cover
Plastic Knockouts
Figure 2-15 Removing the Plastic Knockouts
8. Replace the Main-Cover and fasten two screws.
Two screws
Hooks
Main-Cover
Figure 2-16 Replacing the Main-Cover
ISSUE 6.0
SL1100
Hardware Manual 2-11