Items List of Contents QTY Note
IP4WW-4COIDB-B1 4COIDB-B1 PCB 1
Nylon Spacers 2
4COIDB Label 1
Metal Spacers 1
Screws (with circular washer) 2
IP4WW-000E-B1 000E-B1 PCB (with PKG Spacer) 1
Nylon Spacers 2
Metal Spacers 2
Screws (with circular washer) 2
IP4WW-2BRIDB-C1 2BRIDB-C1 PCB 1
Nylon Spacers 2
2BRI Label 1
Metal Spacers 1
Screws (with circular washer) 2
IP4WW-1PRIU-C1 1PRIU-C1 PCB (with PKG Spacer) 1
Nylon Spacers 2
Metal Spacers 2
Screws (with circular washer) 2
3.3 Mounting the Expansion Interface Card
Enhancements
The 000E-B1 PCB mounted on the KSU required Main software V1.3 or higher.
DO NOT POWER ON until all installation has been completed.
Fit the optional 4COIDB-B1/2BRIDB-C1 daughter boards before installing the 084M-B1/080E-B1/008E-
B1/000E-B1 PCBs.
Set the switches on the 2BRIDB-C1 board before mounting it onto the 084M-B1/080E-B1/008E-B1/000E-
B1 PCB.
3.3.1 Mounting the 080E-B1/008E-B1/000E-B1/1PRIU-C1 PCBs
The procedure for mounting the expansion interface cards is as follows;
• Do Not Power on until all installation have been completed.
• If Expansion KSU(s) are installed, turn the power on/off in the order of
Expansion 2 KSU, Expansion 1 KSU and then Main KSU.
1. Turn off the system power and disconnect the AC cord from KSU.
ISSUE 6.0
SL1100
Hardware Manual 2-43
To Next Page
Loading...
