NEC SL1100 - Mounting the 2 BRIDB PCB; Figure 2-73 Plastic Knockouts on 084 M-B1;080 E-B1;008 E-B1;000 E-B1; Figure 2-74 Installing the 2 BRIDB-C1

3.3.3 Mounting the 2BRIDB PCB
Set the switches on the 2BRIDB-C1 PCB before mounting onto the 084M-
B1/080E-B1/008E-B1/000E-B1 PCB, refer to the Switch Setting on
page 2-57.
1. Cut and remove specified Plastic Knockouts on the 084M-B1/080E-B1/008E-B1/000E-B1 PCB.
084M-B1
080E-B1/008E-B1
Plastic
Knockout
Plastic
Knockout
000E-B1
Plastic
Knockouts
Figure 2-73 Plastic Knockouts on 084M-B1/080E-B1/008E-B1/000E-B1
2. Insert two Nylon-spacers into the specified holes. Using supplied screw, fasten Metal Spacer to
2BRIDB-C1 PCB.
3. Mount the 2BRIDB-C1 PCB onto the 084M-B1/080E-B1/008E-B1/000E-B1 PCB using two Nylon-
spacers and one screw. (Refer to Figure 2-74 Installing the 2BRIDB-C1 on page 2-51)
SL1100 ISSUE 6.0
2-50 Installation