NEC Univerge MH250 - TO ANSWER A CALL; TO MAKE A CALL

10
• TO ANSWER A CALL
When receiving an incoming call, the display
automatically changes to Incoming Call screen.
- To answer the call, press key or soft
key.
- To stop the ring without answering the call, press
key.
- To end the call, press key.
• TO MAKE A CALL
To make a phone call, do either of the following:
- Enter the phone number and then press key or
press soft key. (preset dialing)
- Press key and then enter the phone number.
(overlap dialing)
When the calling party is assigned with a name
information in the PBX, the registered name is
displayed.
When the calling party has been already regis-
tered in the Phone Book, the registered name
is displayed. However, the name information
assigned in the PBX takes precedence over the
name information registered in the Phone
Book.
Incoming Call
John
PM 02:58
Answer
Answer
POWER
POWER
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu
OK
When the dialed number is assigned with a
name information in the PBX, the registered
name is displayed.
The name information assigned in the PBX
takes precedence over the name information
registered in the Phone Book.
By pressing key, you can delete the last
digit of the dialed number that is currently dis-
played on the phone when preset dialing is
used.
To make a call to a 1-digit station, first press
key and then dial the number.
Start Dialing
Eric
PM 02:58
Answer
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu
CLEAR
TIP
01:AbcDefg
02:HigkLmn
03:OpqrStu