4
© by NECTA VENDING SOLUTIONS SpA 0301 162-00
SALES PRICES
A different programmable price can be set for each selec-
tion.
The standard setting has the same price for all selections.
COIN BOX
Made of plastic with lock as optional accessory.
WATER SUPPLY
From the mains, with a water pressure of 5 to 85 N/cm
2
.
AVAILABLE ADJUSTMENTS
Grade of grinding, water doses for coffee by volume.
Time adjustment for instant product and water doses.
Temperature control
Factory set on the correct operating temperature.
A trimmer located on the control board allows small adjust-
ments (as necessary).
CONTROL DEVICES
- Presence of cups
- Presence of water
- Presence of brewer unit
- Liquid waste container full
- Operating temperature reached
SAFETY DEVICES
- Door switch
- Presence of liquid waste container
- Manual-reset boiler safety thermostat
- Air-break float jamming
- Overflow solenoid valve
- Liquid waste container float
- Time protection for:
Pump
Brewer unit ratiomotor
- Overheating protection for:
Doser units
Brewer unit ratiomotor
Magnets
Pump
Electric mixers
- Fuse protection for:
Electronic card power supply transformer
Executive power supply transformer
CAPACITY OF CONTAINERS
Coffee beans 1.2 Kg
Decaffeinated coffee 0.7 Kg
Sugar 1.9 Kg
Powdered milk (standard) 0.8 Kg
Powdered milk (plus) 1.0 Kg
French vanilla 1.9 Kg
Chocolate 1.5 Kg
Stirrers (N.) 245
POWER CONSUMPTION
The machine power consumption depends on many fac-
tors, such as the temperature and ventilation of the room
where it is installed, the inlet water and boiler temperature,
etc.
Under average conditions, and namely:
- ambient temperature: 22° C
- boiler temperature: 93° C
- inlet water temperature: 18° C
- average water dose per selection: 93 cc
the following power consumption resulted:
- to reach operating temperature 53 Wh
- for each hour of stand-by 110 Wh
- for each selection (average) 7.65 Wh
The above power consumption calculated from average
data should only be taken as an indication.
ACCESSORIES
A wide range of accessories can be installed on the
machine to change its performance:
The assembly kits are supplied with their own installation
and test instructions, which must be strictly observed to
ensure the machine's safety.
Installation and the following testing operations, must
be carried out only by qualified personnel who have
the specific knowledge of the machine functioning
from a point of view of both electrical safety and health
regulations.
To Next Page
Loading...
