Necta Canto Plus Espresso - Statistics Management and Protocols; Electronic Counter Operations; EVA-DTS Data Transfer; Communication Protocol Selection

© by N&W GLOBAL VENDING S.p.A. 39 10 2009 3325 - 00
STATISTICS
elecTronic counTer
To display The elecTronic counTer
An electronic counter is intended to store all the dispens-
ing cycles you have performed since you last reset it in
an aggregated manner.
To reseT The elecTronic counTer
You can reset the electronic counter.
To display The elecTronic counTer aT The sTarT-
up
Function used to enable or disable the display of the
total number of dispensing cycles that have been sold
since you last reset the statistics, while you are powering
on the machine.
eva-dTs
Two codes are used to identify the machine and recog-
nise the data transfer terminal according to the EVADTS
(European Vending Association Data Transfer System)
communication protocol:
STATISTICS
EVA-DTS
DEX - UCS
DDCMP ENHANCED
TECHNICIAN> X.X
communicaTion proTocol
Use this function to decide which communication proto-
col to use for the communication of the date acquisition
device.
Available communication protocols are listed here below:
ddcmp enhanced
the following parameters can be congured:
- Pass code: it is a 4-digit alphanumeric code (0-9; A-F)
that must be the same as the one of the data transfer
terminal for identication purposes.
Set to 0000 by default.
- Security code: it is an alphanumeric code for mutual
recognition between the machine and the EVADTS
terminal.
Set to 0000 by default.
- End of transmission: if enabled, it can recognise the
end-of-transmission signal sent to the latest package
and interrupt data transmission.
dex/ucs
no parameter can be congured for this protocol:
daTa Transmission
Function used to select which communication interface
to use for the data transfer. The following interfaces are
made available:
- “RS232” and “IrDA”: to dialogue with data acquisition
devices
- “ALWAYS EVADTS”: to dialogue with data acquisition
and transmission devices (telemetry)
Transmission speed (BaudraTe)
To set up the transmission speed in use for communica-
tion (2400, 4800, 9600, 19200 bps).
Set to 2400 bps by default.
connecTion
If you activate this function, the machine will be waiting
for connection with a device in order to acquire EVADTS
data.
display general
Press the Enter key

to display the data you have
stored in sequence, i.e.:
1 - counter by single selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
reseT general
Statistics can be reset either globally (all types of data)
or selectively, i.e. by:
- selections
- discounts-overprices
- failures
- coin mechanism data
Press the Enter key

to display the request for conr-
mation “Do you conrm?”

ashing on and o.
Press the Enter key to display the “Execution” message
for some seconds and to reset statistics.
display relaTive
Press the Enter key

to display the data you have
stored in sequence, i.e.:
1 - counter by single selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.