Nederman HV Control Panel EX Series - MAIN - Service Hours

HV Control PanelEN
20
(F) Manual start buons:
Dependingonthesystemconguraon,thefollowingbuonsarevisible:
• Filter:Filtercleaning.
• AEB:EmptyingbyAEB.
• TVFD:EmptyingbyTVFD.
• PreSep:EmptyingofPreSeparator.
• Rotary
• Flush.
Filtercleaningandushneedsavacuum,whichcanonlybeperformedinRunningmode.
EmptyingofAEB,TVFDandPreSepcanalsobeperformedwhennotinRunningmode.
Therearecountdownmersthatshowthemetothenextsequencefortheevent.
FiltercleaningandTVFDmustnotoperatesimultaneously.Alightgreenbuonindicates
thatthemerisinawaingstate.
(G) Weekme and Overme/Timer
Seegure3andgure7.IndicatorsfortheWeekmerandtheOvermebuonaremade
visibleusingtheWeekmeSengsbuonintheSengsscreen.Weekmerisusedtoset
thecontrolpaneltorunthesystemonaregularweeklyschedule.Seesecon6.6. Sengs.
PresstheOvermebuon,orusearemotecontrolswitchtoenableittotemporarilyadd
extrametooperatethesystem.See10. Remote Standby/O/Overme.
WhentheWeekmerperiodisacve,overmeisinawaingmodeanditsbuonislight
green.WhentheWeekmerperiodexpires,theOvermebuonbecomesgreenandthe
overmestartstocountdown.
Theacvatedoverme,inwaingmode,canbedeacvatedbypressingthebuonfortwo
seconds.Tostopthesystem,usetheStopbuon.
Seegure4(A).IfWeekmerisnotenabled,Overmecanbeenabledbutbuonis
displayedasaTimerbuon.Usethemertotemporarilyturnonandoperatethesystem
forasetperiodofme.
(H) Vacuum, SSR and DIR
Vacuumisvisbibleifasensorisinstalledandcongured.Ifthepilotsignalisdeacvated,
theDIR(RBUonly)andSSRarevisiblewhentheycountdown.
6.5 MAIN - Service hours
TheStatuseldisthesameasinMAIN.Seesecon6.4. Main.