EasyManua.ls Logo

Nederman HV Control Panel EX Series - Operational Modes; System Start and Standby; Stop and Off Functions

Nederman HV Control Panel EX Series
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HV Control Panel
39
EN
Keepthisreportandlistofsengsforanyfuturemaintenanceandservice.
7 Remote emptying
InaddiontotheemptyingstartbuonsintheHMI,aremotebuoncanbeinstalledby
theunittobeemped.ConnecttheremotetoI1.4,terminals55-56.
ThefunconwilliniateemptyingofAEB/TVFDandPreSepwhenapplicable.
8 On/StandBy/Start
ThesystemcanbesettoStandbywith:
1. PressbuononHMI.
2. Weekmer.
3. Overmer.IfnoacveWeekmerperiod,thenacvaonofOvermewillsetStandby.
4. Remote,whenacvaonaervesecondsinOmode.
Prevenon of start
Ifthereareacvealarms,thesealarmsmustberesetbeforearestart.Thereisno
automacrestartwhenpressing“Reset,andanaddionalpressontheStartbuonis
requested.PresstheStartbuon.
IfRemotestartinputisnotacve,thenthefollowingmessageisdisplayed,“Startinhibitby
Remote”andhighlightede.g.,itisashing.
IftheWeekmervalidperiodhasastartmebeforethecontrolpanelisturnedon,
thenpresstheStartbuonifautomacstartisnotselected,seesecon6.6.9. Sengs -
Weekmer.
Y/D start
TheHVControlPanelEXusestheY/Dstartmethod.
DuringY-mode,themotorpowerisreducedbyastart-upvalve,andnotacvated.Alsothe
ASCisbeclosed.WhenchangingtoD-modethestart-upvalveisacvatedandalsotheASC
willbeenabled.
TheD-modeissupervisedbythePLC.IfD-modeisnotindicatedaerstartwithin60
seconds(normalstart15seconds)thenthereisanalarm.
9 Stop/O
Thereareeightstopfunconsinahierarchy:
1. E-stop:AlarmandgotoOFF.
2. Alarm:GotoOFF.
3. RemoteStandBy/O/Overme(I0.6):GotoOFF(5seconddelayif“Weekmer/
Overmeisenabled).
4. Stop/Obuon:GotoOFF.
5. Weekmerperiodexpired(Ifnooverme,gotoOFF).
6. Overmeexpired(gotoOFF;overmeisresetbyWeekmerStart).
7. SSRmeexpired:GotoStandby.
8. Pilotsignal(I0.0)deacvated(inparallelwiththeTestStartbuonreleased)delayed
bySSRme.

Table of Contents

Related product manuals