Neousys Technology POC-200 - SATA Connector

POC-200 Series User’s Manual
Copyright © 2014 Neousys Technology Inc. All Right Reserved. Page 31 of 78
POC-200 series provides one 204-pin, SODIMM socket for memory installation. It supports
a m
a
x
imal 8GB capacity by installing one low-voltage 1.35V DDR3L-1333 SODIMM
modules. For information of installing DDR3L memory modules, please refer to section 3.2
for detail.
Note
Please make sure you’re installing a 1.35V DDR3L SODIMM module to POC-200. Installing a 1.5V
DDR3 SODIMM will cause system failed to boot.
2.4.4 SATA Connector
POC-200 series provides one SATA port to accommodate a 2.5” SATA hard drive inside it.
The SATA port is located on the daughter board via a 22-pin SATA connector. With the
HDD bracket shipped with POC-200 series, you can directly mount a 2.5” HDD or SSD to
this port. For information of installing a HDD/SSD to SATA port, please refer to section 3.3
for detail.