Neousys Technology POC-200 - Install a DDR3 L SODIMM Module

POC-200 Series User’s Manual
Copyright © 2014 Neousys Technology Inc. All Right Reserved. Page 40 of 78
3. Unscrew 4 hex bolts on the top of the heat sink.
4. Gently slide out the assembly of case.
3.2 Install a DDR3L SODIMM Module
Note
Please make sure you’re installing a 1.35V DDR3L SODIMM module on POC-200. Installing a 1.5V
DDR3
SODIMM will cause system failed to boot.
1. Follow the steps in section 3.1.1 (POC-200/210) or section 3.1.2 (POC-212/222) to
dissemble your POC-200 series. You can see the DDR3L socket exposed.