Trident Installation: Preface
This guide will illustrate how to physically install the Trident.
The guide below will walk through the different steps illustrated on the Get
Started card included with your Neptune Systems Trident, but the
recommended method is to use the Trident Initial Setup task found in Apex
Fusion. The guide can also be used to supplement the Trident Initial Setup
Task and provide additional information for those looking for further details.
DO NOT CONNECT THE TRIDENT TO YOUR APEX
..
While this may seem counterintuitive, do not connect your Trident to the
Apex until instructed to do so. Connecting the Trident before other
necessary connections are made will cause the Trident to go into an error
mode and will cause the installation of the system to take additional time.
Update Apex AOS
.
On the Apex dashboard click the button with 3 gears, then click the WiFi
button. If there is not a large orange Update AOS button, then your Apex
already has the latest AOS version installed. If you see a large orange
Update AOS button, click that button and then click the Update button
The minimum required AOS version for the Apex is 5.05_5D19.
To Next Page
Need help?
General