Ensure that the power supply cord is properly connected to the Trident power input jack. Also verify that
the power supply has AC input power.
Neptune Systems does not recommend plugging the Trident power supply into an EneryBar outlet. But if
you have done so, the EnergyBar outlet must be programmed to be always on, like this:
Fallback ON
Set ON
Error Condition
Waste Full
Explanation of Error
Waste Full
The “Waste Full” error occurs because the waste container is completely full.
Recommended Course of Action
Waste Full- Container
To resolve this:
1. Empty the waste container
2. From the Trident tile click the gear and select "Configure Trident"
3. Select "Reset"
4. Select "Waste"
5. Sent the update to Apex Fusion
The error should clear in about a minute.
Waste Full- Drain
To resolve this:
1. From the Trident tile click the gear and select "Configure Trident"
2. Select "Waste lne"
3. Select "Drain"
4. Sent the update to Apex Fusion
The error should clear in about a minute.
To Next Page
Loading...
Need help?
General