Review Package Contents
Items included with the Neptune Systems Trident: (Select a link for more
information, click it again to dismiss the pop-up)
Trident Marine Aquarium Water Analyzer
Two Month Reagent Kit
Trident Calibration Solution
1LINK Cable
Sample Line Tubing and Holder
Waste Line Tubing
Connect Black Sample Line Tubing
.
It is suggested to make the initial connections to the Trident in an open
space. The first connection that should be made is to connect the black
sample line tubing to the black connector on the back of the Trident.
—DO NOT EXTEND OR SHORTEN THE LENGTH OF THE TUBING—
Altering the length of the sample tubing will cause significant issues with the
proper measurement of the Alkalinity, Calcium, and Magnesium levels.
Connect Waste Line Tubing
.
Connect the clear waste line tubing to the clear connector on the back of the
Trident. Place the other end of the waste tubing in a suitable container. The
minimum recommenced capacity of the waste container is 2
liters. Optionally, if you have a drain close by, you may place the far end of
the waste tubing into that drain.
Like with the sample line tubing, do not cut or extend the waste tubing.
Connect 1LINK Cable to Trident
.
Connect the 1LINK cable to the 4-pin jack on the back of the Trident.
Customers outside the US and Canada and those without an available 1LINK
port, connect the Aquabus cable and power supply.
— DO NOT CONNECT THE CABLES TO THE APEX YET —
To Next Page
Loading...
Need help?
General