Ness D16 - DISARMING

NESS D16 CONTROL PANEL - USER MANUAL
10
When you enter the protected premises
through a delay zone, the keypad responds
with regular beeps* as a reminder to Disarm.
You then have your programmed entry delay
time to Disarm the panel by entering one of
your user codes. If the panel is not Disarmed
by the end of the entry delay time, an alarm
will occur.
By using the optional radio keys you may
Disarm your system from within your
premises or from outside your entrance door.
1. Enter the protected premises via a delay zone
2. Press
[User Code]
...or by RADIO KEY, press the OFF button
3. The ARMED light will turn off
DISARMING
There is also the option to ‘Chirp’ the outside
siren three times and to flash the strobe light
for two seconds as an indication that you
have Disarmed your system.
If you make a mistake in entering your code,
then you must press enter and start again.
Five incorrect entries will cause an alarm.
* If Entry Beeps are programmed on.
DISARMING YOUR ALARM SYSTEM
Your panel can be reset and the alarm
silenced by the same key sequence as
Disarming the panel.
If you arrive at your premises and find the
strobe light flashing (if installed), reset the
panel as above. To check the cause of the
alarm, you can view the alarms in memory
by entering Memory Mode.
1. Press
[User Code]
...or by RADIO KEY, press the OFF button
RESETTING AN ALARM
Technical Manuals Online! - http://www.tech-man.com